Industrial and panel PCs
Panel PCs and box PCs: selection, cooling, ratings and installation.
Latest articles
Selection guide
Qualifying an industrial PC after an MLC to TLC SSD change
Accept the TLC configuration when the delivered SSD's specified TBW divided by your measured daily host writes exceeds the service life the machine needs. MLC stores 2 bits per cell and TLC stores 3, moving manufacturer per-cell cycle ratings from 4000-plus down to 900-1200, but capacity and spare area set the drive's TBW. Decide on the delivered drive's numbers, not the NAND label.
How-to
Using a KVM extender to run an HMI from a panel IPC
Yes — mount the IPC in the control panel and put a purpose-built KVM extender pair between it and the operator station, so one Cat6 run carries video and USB to where grit and heat destroy exposed computers. It works only if the model supports your video output, the display's resolution and refresh rate, and every USB device, and the link stays point-to-point. Size the run against the model's stated length, not against the Cat6 label.
Checklist
Running a compact industrial PC as an always-on server
Yes, a compact fanless industrial PC can host small IoT, VPN and SCADA services for years, but its rugged build guarantees survival, not capacity. Qualify the exact model against measured peak load: CPU below 70%, memory below 75%, SSD write endurance with margin, thermal margin at the site, and a restore test that proves recovery.
How-to
Identify HMI software before replacing an unknown panel PC
The model number on a panel PC names the hardware only. Before you buy a replacement, identify the HMI software: record the application name, window title, and version from the operator screen, then work through delivered documentation, installed files, and the machine builder. A matching panel size proves nothing about software compatibility.
Troubleshooting
How to prove an IPC slowdown is hardware not software
A slow HMI on a booting IPC is not fault evidence. Capture per-process CPU, memory, disk and network under the production workload first: saturation with a clean event log is a sizing or software problem, and only an error that repeats under a separate one-component stress load — twice, with a matching Windows event — convicts the hardware.
Troubleshooting
Feeding a High -12V Load in an Industrial PC
Total ATX wattage never raises the negative rail: retail units label it 0.3-1.0 A and the highest you will find is 1 A. Measure the grabber cards' peak draw on that rail with a series ammeter, then feed it from an isolated 12 V DIN-rail supply with its V+ tied to PC 0 V, sized to 1.5 times the measured peak, and remove the ATX wire from pin 14 so the two sources do not fight.